If it was a reasoning only, the address you've set for the signals look fine. What I'm going to say you is based on my experience, not on a reasoning. The signals for minus side should be emptyĢ - Now the signals.
main signal for + side is SG09W, and distant signal for + side is Vr09WB. They must be associated both to the + side of block 09, i.e. However, I went to the Rocrail forum and downloaded your issue.zip file and played with it under Rocrail.ġ - The assignment of main (SG09W) and distant signal (Vr09WB) in block 09 is wrong. Well, signals with more than 2 aspects in Rocrail is not really obvious.Īt least, I've not entirely understood the concept ? So I am hoping to find someone who has it functioning properly through a similar setup as mine.Īny suggestions are appreciated, since I have 16 of these to configure. I have posted an Issue on the Rocrail Forum but so far no one has been able to provide me with something to check why the decoder will not respond for the distant signal output, but responds to all other signal outputs.
It functions properly in Manual from either the CS2 or Rocrail, but in Automatic it stays stuck in the Vr0 aspect, even though the Rocrail plan view shows an aspect change has occurred and the appropriate output has been sent.
However, for a week now I have been trying to get a distant signal to work in association with its corresponding main signal with no success through Rocrail Automatic. I have successfully configured my main signals and they operate through Rocrail as they should. I am wondering if anyone on this forum has the same hardware and software configuration that I have? In particular a CS2, a LDT Signal Decoder (using Motorola protocol), a Viessmann 4015 entry signal with distant signal and operating through Rocrail.